Journal of Nuclear Science, Engineering and Technology (JONSAT)
In cooperation with the Iranian Nuclear Society

Control Rods Reactivity Worth Measurement in a Mixed Core Heavy Water Zero Power Reactor (HWZPR)

Document Type : Research Paper

Authors

P Kaviani 1
M Mashayekh 1
J Khorsandi 1
H Khalafi 2

1 Reactor and Nuclear Safety Research School, Nuclear Science and Technology Research Institute

2 Reactor Research School, Nuclear Science and Technology Research Institute, AEOI

https://doi.org/10.24200/nst.2018.189
Abstract
Systems related to reactivity control in a heavy water zero power reactor (HWZPR) consist of safety rod, control rod, emergency dump, and water level measurement and regulation systems. The control rod reactivity worth and safety rods should, therefore, meet the necessary safety criteria. The safety rods are used to shutdown the reactor through rapid falls in the emergency of the reactor and for a normal shutting down condition. According to the safety criteria, the equivalent rod reactivity worth must be appreciably greater than the maximum excess of reactivity which occurs in a reactor. The main applications of the control rods are to control the power rising period and the transition from subcritical to supercritical states. According to the safety guide for a HWZPR when a reactor is close to the critical state, the reactivity insertion rate should not exceed 2×10-4 (∆k/k)/s and the reactivity worth of each control rod should be less than 0.2% ∆k/k to ensure the safety of the reactor operation. According to the obtained calculational and experimental results, these conditions are satisfied for HWZPR. By changing the reactor fuel from natural metal uranium to mixed fuel (natural metal uranium fuel and natural oxide uranium), the control rod reactivity worth is measured and according to the obtained results, the control rod reactivity worth can meet the above provisions.

Keywords

HWZPR
Reactivity
Mixed fuel
[1] Preliminary Safety Analysis Report on heavy Water Zero Power Reactor, China Institute of       Atomic Energy, (1992).
 [2] John  R. Lamarsh  Introduction to Nuclear Reactor Theory, New York University, (1972).
 [3] J.S. Glaston, Nuclear Reactor Engineering, Van Nostrand Reinhold Company, (1994).
 [4] F. Briesmeister, MCNP A General Monte Carlo N-Particle Transport Code System (version C),       Los Alamos, National Laboratory, Los Alamos, New Mexico, (2000).
 [5] M.J. Halsall, A Summary of WIMSD4 Input Options, (1967).
 [6] M.J. ROTH, The Preparation of Input Data for WIMSD4, General Reactor Physics Division, Atomic Energy Establishment, (1967).
 [7] T.B. Fowler, D.R. Vondy, G.W. Cunningham, National Energy Software Center Note, CITATION, NESC, 387 (1980).
 [8] Z. Nasr, R. Salimi, J. Khorsandi, Neutronic design of HWZPR mixed core, Reactor school, NSTRI, AEOI, internal report, in Farsi, (2012).
 [9] P. Kaviani, M. Jalali, J. Khorsandi, Measurement of Relative Neutron Flux Distribution in HWZPR mixed core, Reactor school, NSTRI, AEOI, internal report, in Farsi, (2013).

Home