Experimental and numerical transient analysis of Tehran Research Reactor (TRR)

Lashkari, Ahmad; Khalafi, Hossein; Kazeminezhad, Hossein; Khakshournia, Samad; Ezati, Arsalan; Keyvani, Mehdi; Hosnirokh, Ashkan

Experimental and numerical transient analysis of Tehran Research Reactor (TRR)

Document Type : Research Paper

Authors

Ahmad Lashkari

Hossein Khalafi

Hossein Kazeminezhad

Samad Khakshournia

Arsalan Ezati

Mehdi Keyvani

Ashkan Hosnirokh

Abstract

In this paper, a numerical model is presented to analyze a series of reactivity insertion and loss of flow transients in TRR. The model predictions are compared with the experimental data and PARET code results. The model uses the piecewise constant method and the lumped parameter methods for the coupled point kinetics and thermal-hydraulics modules, respectively. The advantages of the piecewise constant method are simplicity, efficiency and accuracy. A main criterion for the applicability range of this model is that the exit coolant temperature remains below the saturation temperature, i.e. no bulk boiling occurs in the core. The calculated values of power and coolant temperature, in both positive reactivity insertion and loss of flow scenario’s, are in good agreement with the experiment values. However, the model is a useful tool for the transient analyses of most researches encountered in reactors in practice. The main objective of this work is using simple calculation methods and benchmarking them with the experimental data. This model can also be used for training purposes.

Keywords

Tehran Research Reactor

Thermal-hydraulic

Reactivity insertion

Loss of flow

[1] S.M. Khaled, Numerical modeling of reactivity excursion accidents in small light water reactors, department of nuclear techniques institute of nuclear techniques budapest university of technology, PHD Thesis (2006).

[2] T. Hamidouche, A. Bousbia-Salah, M. Adorni, F. D’Auria, Dynamic calculations of the IAEA safety MTR research reactor benchmark problem using RELAP5/3.2 code, Annals of Nuclear Energy, 31, (2004) 1385-1402.

[3] W.L. Woodruff, A kinetics and thermal-hydraulics capability for the analysis of research reactors, Nuclear Technology, 64 (1984) 196–206.

[4] M.A. Gaheen, Simulation and analysis of IAEA benchmark transients, Annals of Nuclear Energy, 49 (2007) 217–229.

[5] H. Kazeminejad, Thermal-hydraulic modeling of flow inversion in a research reactor, Annals of Nuclear Energy., 35 (2008) 1813–1819.

[6] D.L. Hetrick, Dynamics of nuclear reactors, (1972).

[7] H. Kazeminejad, Reactivity insertion limits in a typical pool-type research reactor cooled by natural circulation, Annals of Nuclear Energy., 33 (2006) 252–261.

[8] M. Kinard, E.J. Allen, Efficient numerical solution of the point kinetics equations in nuclear reactor dynamics, Annals of Nuclear Energy, 31 (2004) 1039–1051.

[9] C. Housiadas, Lumped parameters analysis of coupled kinetics and thermal-hydraulics for small reactors, Annals of Nuclear Energy., 29 (2002) 1315-1325.

[10] F.W. Dittus, L.M.K. Boelter, Publications on engineering, University of California, Berkeley, 2 (1930) 443.

[11] A. Lashkari, H. Khalafi, S.M. Mirvakili, Neutronic analysis for Tehran Research Reactor mixed-core, Progress in Nuclear Energy., 60, (2012) 31-37.

[12] A. Lashkari, H. Khalafi, H. Kazeminejad, Effective delayed neutron fraction and prompt neutron lifetime of Tehran research reactor mixed-core, Annuals of Nuclear Energy, 55, (2013) 265-271.