نوع مقاله : مقاله پژوهشی
نویسندگان
پژوهشکده کاربرد پرتوها، پژوهشگاه علوم و فنون هستهای، سازمان انرژی اتمی ایران، صندوق پستی: 3486-11365، تهران ـ ایران
کلیدواژهها
عنوان مقاله English
نویسندگان English
Electron accelerators use electric and magnetic fields to accelerate and control charged particles to the close proximity of the speed of light. The results of the experimental test performed on the Yazd Rhodotron cavity cooling system as well as the relevant numerical analysis carried out by the ANSYS 12 code are presented. It was found that the numerical prediction for the cavity wall temperature under normal operating condition was in reasonable agreement with the corresponding experimental result. In addition, due to the blockage effect of the cooling channels, the cavity wall temperature was higher than normal operating conditions.
کلیدواژهها English
J. Pottier, A new type of RF electron accelerator: the Rhodotron, Nuclear Instruments and Methods in Physics Research B 40/41 (1989) 943-945.
J.M. Bassaler, J.M. Capdevila, O. Gal, F. Laine, A. Nguyen, J.P. Nicolaj, K. Umiastowski, Rhodotron an accelerator for industrial irradiation, Nuclear Instruments and Methods in Physics Research B68 (1992) 92-95.
Y. Jongen, M. Abs, J.M. Capdevila, D. Defries, F. Genin, A. Nguyen, The Rhodotron, a 10 MeV, 100Kw beam power metric waves, CW electron accelerator, presented at the 7th All-Union Conference on applied accelerators, June 16-18, St Petersburg (CIS) (1992).
Y. Jongen, M. Abs, F. Genin, A. Nguyen, J.M. Capdevila, D. Defries, The Rhodotron, a new 10MeV, 100Kw, CW metric wave electron accelerator, presented at the International conference on the application of accelerators in research and industry, November 2-5 (1992) Denton (USA).
S. Humphries, Principles of charged particle accelerator, John Wiley and Sons (1986).
S. Humphries, Charged particle beams, John Wiley and Sons (2002).
J.P. Holman, Heat transfer, Tenth Edition, McGraw-Hill (2009).
S.W. Churchill and S.W.H. Ozee, Correlation for laminar forced convection in flow over an isothermal flat plate and in developing and fully developed flow in an isothermal tube, Journal of Heat Transfer (95) (1973).
ASTM A 516/A 516M-04, Standard specification for pressure vessel plates, Carbon steel, for moderate- and lower-temperature service, American society for testing and materials standards (2004).
ASTM A 666–03, Standard specification for annealed or cold-worked austenitic stainless steel sheet, strip, plate, and flat bar, American Society for Testing and Materials Standards (2004).
